Full chain now decodes the QO-100 central beacon to 256-byte AO-40 frames
on-air (frames>0, RS errors=0). Builds on M1 (stable BPSK demod).
FEC backend (BeaconFEC.pas, TBeaconFEC):
- AO-40 FEC: distributed sync (65 bit, step 80) -> 80x65 deinterleave ->
Viterbi r=1/2 k=7 -> CCSDS descramble -> 2x RS(160,128). Links system
libfec (Karn) load-time (libfec.so/.dll/.dylib). Viterbi AO-40 [0x4F,-0x6D]
remapped to libfec [0x6D,0x4F]. Validated against gr-satellites reference
vectors (fectest2: exact 256-byte frame, 0 mismatches).
DBPSK Manchester frontend (BeaconDecoder.pas):
- Chip-rate (800) processing: RRC matched filter -> ML signal-times-slope
timing recovery -> Costas -> Manchester combine (block phase select) ->
differential decode -> soft symbols to FEC.
- Carrier acquisition: squaring-FFT estimates the residual (carrier at +-pi/chip
defeats decision-directed Costas), one-shot pulls it to DC via residual NCO.
- Costas frequency offload into pre-RRC NCO (with deadband) tracks LNB drift
without hitting the +-pi Costas clamp.
- ML TED replaces Gardner, which degenerates on the Manchester chip stream.
Temporary on-air diagnostics retained (IQ dump + STATE log) pending wider
signal validation; to be removed before final cleanup.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Add ADALM-Pluto / AD9361 support as a second hardware backend alongside
openHPSDR, sharing the WDSP DSP pipeline and the existing controller API
(UI stays decoupled from logic).
- RadioBackend.pas: abstract TRadioBackend + TBackendCaps + TRadioDevice
(Kind/URI/Serial). THPSDRNetwork now derives from it (state via virtual
getters); TRadioController.FNetwork is the base type.
- IIOBindings.pas: dynamic libiio loader (runs without libiio present).
- PlutoBackend.pas: scan/probe-by-URI, connect, LO/rate/bandwidth/gain
control, RX streaming thread (int16->24bit BE -> OnDDCIQ), Q conjugated
to match WDSP IQ convention. Verified on LibreSDR (AD9361) over network.
- Unified discovery: TDiscoverThread scans both backends; network Plutos
found via direct ProbeURI (no mDNS needed). ConnectDevice dispatches by
Dev.Kind (EnsureBackend swaps backend, preserving callbacks).
- DeviceStore/DeviceForm: persist Kind/URI/Serial; save Pluto via
AddSavedPluto so saved/autostart devices reconnect across restarts.
- VHF/UHF band plan (BoardUtils, kind-aware): 6m..ADS-B for Pluto; fixes
HF clamps (band detect, mouse-wheel 60 MHz cap, freq-display max).
- SampleRateOverlay: configurable presets (Pluto 576k..5760k, >520 ksps),
auto-width to fit.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
OnSpectrumReady/OnWaterfallReady move into TRadioController. The controller now
owns the last spectrum/waterfall frame (FSpectrumBuf/FWaterfallBuf) for the web
mirror and emits raw pixels via OnSpectrumData/OnWaterfallData. MainForm
subscribes for FSpecView rendering (+ waterfall scroll decimation, a UI concern).
TWebAdapter.PushState now reads the frame from the controller (no buffer params).
Behavior-preserving; removes the last spectrum/waterfall data-path coupling.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
- New ChannelStore.pas: TChannel record + JSON persistence (channels.json)
- New ChannelsForm.pas: full channel editor (list + fields, pre-fills from current radio state)
- CH button in RX block: left-click opens dropdown, right-click opens editor
- Active channel: button highlights with channel name, deactivates on VFO move
- ApplyChannel: auto-switches XVTR/HF band based on channel frequency; saves old
band state before switching to prevent cache corruption
- SaveCurrentBand: skip save when VFO > 61 MHz (prevents HF cache corruption
from VHF channel application without XVTR)
- DeactivateXvtr: save full XVTR state (was only saving LastFreq)
- CTCSS/RPT from channel marked as auto: cleared automatically when tuning away
from channel frequency; survives band switches via FXvtrSettings auto-flags
- TXvtrEntry: add LastCTCSSAutoActive, LastFMRptAutoActive fields
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
Replaces TProgressBar in TWisdomProgressDialog with TFlatProgressBar,
drawn entirely via Canvas (plain rectangle, no native widget styling).
Dialog now receives the active TAppTheme so both dark and light themes
are applied consistently to background, label, and progress bar.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
- Add SampleRateOverlay.pas: TCustomControl overlay (top-left of spectrum)
with hide-panel button and 6 span buttons (48k–1536k), same hit-test
pattern as VfoOverlay
- Consolidate toolbar: move PanelTopVfoGroup and PanelSMeterRight into
PanelToolbar (height 72) instead of floating on the form
- Remove PanelSpanButtons (alTop spacer) that caused the ~1cm black strip
at the top of the spectrum
- Add separator line inside PanelToolbar anchored to its bottom edge,
with 16px left/right margins
- Fix left panel blocks starting Y offset (was 38, now 0)
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
Moves CTCSS tone picker and FM step picker from inline TPanel+TFlatButton
arrays into a standalone FlatDropDown.pas module. TFlatDropDown owns the
popup panel, handles positioning and item selection, and fires OnSelect.
ApplyStyle syncs button colors on theme change.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
TSpectrumView remains the public facade for MainForm; waterfall, S-meter,
and ruler rendering are now in isolated units. Dead code removed.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
- AppTheme.pas: новый файл, TAppTheme record + DarkTheme()/LightTheme()
- FlatSlider: цвета через SetThemeColors вместо хардкода
- SpectrumView: все цвета из TAppTheme (SetTheme)
- SettingsForm: ApplyTheme(T) с рекурсивным обходом контролов
- DeviceForm: SetTheme(T) — перекраска всех элементов включая TEdit
- Settings: SaveTheme/LoadTheme в корневой секции preferences (не привязано к устройству)
- MainForm: тема загружается при старте, сохраняется при изменении
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
- New unit SpectrumView.pas (TSpectrumView): encapsulates all
spectrum, waterfall, ruler and S-meter rendering; ~900 lines
removed from MainForm.pas
- Fix marker bug: FMarkerActive/FMarkerX were duplicated in
MainForm and TSpectrumView — mouse handlers now write directly
to FSpecView, stale MainForm fields removed
- Fix filter band and ruler not following VFO: add SyncSpecViewFreq
helper called at every draw site and at top of SpectrumTimerTick
- Remove dead code: WFALL_PALETTE (34 lines), FSplitter, LblAGC,
LblVol, WinFirewall/IntfGraphics/FPImage from uses
- Fix pre-existing bug: SidetoneFreqLo := 600 overflowed Byte,
replaced with Hi(600)/Lo(600)
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
New units: CATEngine (Kenwood + Thetis ZZ* commands), CATSerial
(up to 4 serial ports), CATTcp (multi-client TCP server on port 4992).
MainForm wired with TCATContext callbacks reusing existing WebOn* handlers.
SettingsForm gets a new CAT tab with 4 serial port groups and TCP section.
Settings.pas extended with CAT config fields (per-device, JSON-persisted).
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
ew8bakandClaude Opus 4.8