Pluto exposes two temperature sensors: the AD9361 transceiver
(ad9361-phy temp0/input, milli-°C) and the Zynq SoC/FPGA (xadc temp0,
raw+offset+scale → C = (raw+offset)*scale/1000). Only the former was
read. Now both are read and shown as "Temp 37/53C" (chip/SoC) in the
desktop status bar and web UI.
- ReadTelemetry gains an out SocTempC param (base + Pluto override);
Pluto reads xadc via the IIO context.
- Controller stores FLastPlutoSocTempC; SoC temp validated with a
plausibility window (no slew-limit — stable local sensor, unlike the
AD9361 sensor that spikes during mid-conversion).
- Status formatting handles one or both temps in MainForm and WebAdapter.
- Widen desktop status-bar field 3 (150→190) so both temps + RSSI fit;
web layout unchanged.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Builds on the beacon-lock baseline: keeps the proven display-FFT control
path (hardware-LO trim folded into the active transverter LOError), and
hardens it. The narrowband NCO/FLL scaffold (BeaconLock.pas) is removed —
it was never in the control path.
- RadioController:
* Persist live: each correction folds straight into the active xvtr
LOError (visible in Settings, survives restart as LNB calibration);
disk writes throttled. FBeaconLockHz is now only a session indicator.
* Robust tracking vs nearby signals: narrow ±2 kHz gate while locked
(±6 kHz only for acquisition), slew-rate outlier rejection (a sudden
centroid jump = interferer, not slow LNB drift → ignored), and lobe
shape validation in MeasureBeaconFFT (width + power symmetry) so a CW
carrier / one-sided neighbour isn't mistaken for the BPSK beacon.
Prominence measured over the in-window noise floor (gate-width robust).
* Fast convergence: feed-forward (predict post-retune position so the
window follows the beacon through the jump) + near-deadbeat correction
on the manual click → one click locks instead of repeated tapping.
* Single central BPSK beacon (10489.750); dead CoarseBeaconOffset and
unused throttle counters removed; stale NCO/FLL/4 Hz comments fixed.
- WDSPEngine: drop the per-sample TBeaconTracker RX-IQ tap (tracker gone).
- MainForm: BEACON is now a plain button, shown only on Pluto in a
transverter. Lock status (off / click / search / LOCK + correction +
prominence) moves to status-bar field 7 in place of PLL on Pluto;
openHPSDR keeps PLL there.
- SettingsForm/StatusBar: widen LO Error field to ±10 MHz (QO-100 LNBs
drift hundreds of kHz) and widen status field 7 for the beacon text.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
ew8bak
