- Settings: TTXSettings record + LoadTX/SaveTX, JSON section "tx" per MAC
- WDSPEngine: separate TX_DISP_ID analyzer with own FFT/Window/Det/Avg
parameters, ApplyTXAnalyzerSettings + setters
- WDSPEngine: full TX chain setters (Filter/Compressor/Leveler/ALC/
PhaseRot/EQ/AMCarrier/FM/CTCSS) + ApplyTXChainSettings
- WDSPEngine: ProcessTXBlock now feeds TX analyzer in DISPLAY_BLOCK_SIZE
chunks (was passing whole FTXOut → analyzer ignored most of it)
- WDSPEngine: ActiveDisplayID switches RX/TX in UpdateSpectrum
- WDSPEngine: RX audio muted while TX active to avoid local feedback
- WDSPEngine: default EQ frequencies in Create (zero freqs broke TX chain)
- WDSPEngine: PushTXMicSampleD + OnPullMicSamples for sound-card path
- AudioInput: Available counter for non-blocking pull
- MainForm: PullSoundCardMic, BuildMicLineSelectByte, SendDUCSpecific
with mic bias/boost/line/PTT bits, OnTXSettingsChange
- MainForm: auto-switch MicSource on TX device select, TX diagnostic
in StatusBar panel [5]
- SettingsForm: new Transmit nav page with Microphone, Filter, Dynamic
processing, EQ, AM/FM/CTCSS, TX Display sections
NOT YET WORKING: sound-card mic produces ring activity but signal still
not visible on TX spectrum/waterfall — needs further investigation.
Co-Authored-By: Claude Opus 4.7 <noreply@anthropic.com>
- AppTheme.pas: новый файл, TAppTheme record + DarkTheme()/LightTheme()
- FlatSlider: цвета через SetThemeColors вместо хардкода
- SpectrumView: все цвета из TAppTheme (SetTheme)
- SettingsForm: ApplyTheme(T) с рекурсивным обходом контролов
- DeviceForm: SetTheme(T) — перекраска всех элементов включая TEdit
- Settings: SaveTheme/LoadTheme в корневой секции preferences (не привязано к устройству)
- MainForm: тема загружается при старте, сохраняется при изменении
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
- Settings.pas: add root-level SaveCATSettings/LoadCATSettings so CAT
config is stored independently of device MAC.
- MainForm.pas FormCreate: initialize CAT defaults, load from saved
'cat' JSON section, and apply immediately after InitCATEngine — so
SettingsForm shows correct values before the transceiver connects.
- MainForm.pas OnCATSettingsChange: always save to root 'cat' section
(not only when device is connected) so changes persist immediately.
- Default TCP CAT port changed from 4992 to 19090 everywhere.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
New units: CATEngine (Kenwood + Thetis ZZ* commands), CATSerial
(up to 4 serial ports), CATTcp (multi-client TCP server on port 4992).
MainForm wired with TCATContext callbacks reusing existing WebOn* handlers.
SettingsForm gets a new CAT tab with 4 serial port groups and TCP section.
Settings.pas extended with CAT config fields (per-device, JSON-persisted).
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
ew8bakandClaude Opus 4.7